SIMPLIFIER MKII
Specs
Main Features
Zero Watt Dual Channel & Reverb Stereo Amp
Stereo TRS input
Stereo TRS thru outputs
2 preamps with 3 amp types and 3 gain modes, each
Preamps can be used as a 2-channel amp, or in parallel for full stereo signal chains
Stereo FX loop, with stereo TRS send jack, and two independent return jacks
Stereo Reverb with 3 modes (Room, Ether and Plate) and mix for each channel
Power amp simulation with presence, resonance, and tube type for each channel
Cabinet simulation with cab type and mic placement for each channel
Two Balanced DI outs with ground lift
Powerful headphone amplifier with volume control and aux input
External footswitch (included) for channel and reverb on/off, compatible with external TRS controllers
Spread switch for widening the stereo imaging or correcting phase issues
Material & Color
Built on heavy-duty aluminum enclosure
Metal knobs
White case
Black and Golden labels
Size & Weight
Height: 120 mm (4.7 inch)
Width: 70 mm (2.7 inch)
Depth: 45 mm (1.8 inch)
Weight: 360 g (0.8 lb)
Impedance
Input Impedance
Input: 1Meg Ohm
L & R return: 1Meg Ohm
Output impedance
Send: 1K Ohm
Unbalanced Outputs: 4.7K Ohms
Ohms Balanced Outputs: 100 Ohms
Headphone Specs
Power: 135 mW into 32 Ohms
Use with 16, 32, 64 and 96 Ohm Headphones.
Loss of power can occur with higher impedance headphones.
Power Supply Requirements
Connector: 2.1 mm DC jack, Center negative
Current consumption: 150 mA
Recommended supply current: 200 mA and up
In the box
Simplifier MKII
Owner's Manual
Fabrication
Designed and handmaded in Chile 🇨🇱
EMC/EMI Emissions & FCC Compilance
The manufacturer claims that the above product fulfills the requirements as set by EN55013, EN55020, EN60555-2, EN60555-3, RoHS, WEEE.
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation.
If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
Warranty
All of our products have a 2 year warranty covering production defects or malfunctions.
If you have any issue with your unit, please contact your dealer or contact us at support@dsmhumboldt.com