Specs
Main Features
All Analog two channel zero-watt guitar amplifier with stereo reverb, fully packed with routing and tone sculpting options.
2 fully independent Amplifier channels, A & B.
Preamp, power amp and cabinet type selector for each channel.
Dual FX loop send.
Dual FX loop Return.
Dedicated stereo thru output.
Stereo Reverb with three modes (room, ether and plate).
Power amp simulation with Power amp Type, Power amp Drive, Presence and Resonance for each channel.
Cabinet simulation with cab type and Speaker color for each channel.
Two Balanced DI outs with ground lift.
Headphone amplifier with volume control.
Auxiliary input that can be routed to the main output or headphones only.
3 modes of operation (Full Parallel, 2 channel with stereo cabinet simulator and 2 channel dual mono).
Mono Loop switch for mono fx into both returns.
2 1⁄4 inch outputs with Cab Bypass option.
Footswitchable channel selection (footswitch included).
Material & Color
Built on custom made anodized aluminum case.
Aluminum knobs.
Case in sandblasting/frosted black finish.
White and Silver labels.
Size & Weight
Height: 120 mm (4.7 inch).
Width: 95 mm (3.7 inch).
Depth: 50 mm (2 inch).
Weight: 360 g (0.8 lb).
Impedance
Input Impedance
Input: 500 k Ohms.
L & R return: 1 Meg Ohm.
Output impedance
Send: 1 K Ohm.
Unbalanced Outputs: 4.7 K.
Ohms Balanced Outputs: 100 Ohms.
Pre boost: 30 dB
Post boost: 20 dB
Headphone Specs
Power: 135 mW into 32 Ohms.
Use with 16, 32, 64 and 96 Ohm Headphones.
Loss of power can occur with higher impedance headphones.
Power Supply Requirements
Recommended supply current: 50 mA and up.
In the box
Silver Linings Unit.
Owner's Manual.
Fabrication
Designed and handmaded in Chile 🇨🇱
EMC/EMI Emissions & FCC Compilance
The manufacturer claims that the above product fulfills the requirements as set by EN55013, EN55020, EN60555-2, EN60555-3, RoHS, WEEE.
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation.
If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warranty
All of our products have a 2 year warranty covering production defects or malfunctions.
If you have any issue with your unit, please contact your dealer or contact us at support@dsmhumboldt.com.